Hue switch console
Sign in

How-to

Build a switch, set it up, change what it does, and read what it's telling you. Pick your switch to start.

Build a Round switch

What to buy, soldering the headers if they came loose, and how the parts go together.

Built by the maintainerBuilt and in use by the maintainer, one installation.

Low voltage only. Never connect any pin to anything that is or was on mains.

What to buy

  • 1Seeed Round Display for XIAOseeedstudio.com ↗

    The 1.28″ round touch screen and its board. The XIAO plugs into the sockets on its back.

  • 2Seeed XIAO ESP32-S3seeedstudio.com ↗

    The plain S3. It must be an S3: the C3 and C6 don't run the Round firmware. The S3 Sense (with camera) fits the display but hasn't been tested with this firmware.

  • 3Pin headers

    Two strips of 7 pins. Seeed sells the XIAO with them loose in the bag or already soldered. Loose ones have to be soldered on (step 1); pick the pre-soldered XIAO to skip that.

  • 42.4 GHz antenna

    Comes in the XIAO's bag. Without it the screen says No Wi-Fi.

  • USB-C cable that carries dataYou may have it

    For the install. Charge-only cables are the most common reason the board never shows up on Setup.

  • USB-C phone chargerYou may have it

    Any 5 V charger, to power the switch where it lives.

  • Soldering iron and solderYou may have itOptional

    Only for loose headers. A fine tip and a few minutes.

Put it together

A few minutes, plus soldering if the headers came loose. Do it before you plug in USB.

  1. 1

    Solder the headers (skip if they came soldered)

    Push both strips in from the back of the XIAO, the side without the chip, so the short ends come up through the holes on the chip side. Solder all 14 pins there. The long pins point away from the chip. Pressing the long pins into a breadboard holds the strips straight while you solder.

  2. 2

    Plug in the antenna

    Its small round U.FL plug goes on the matching socket on the chip side, at the end away from the USB-C port. Line it up and press straight down until it clicks.

  3. 3

    Set both DIP switches to ON

    Turn the Round Display over. Between the sockets and the microSD slot is a small block of two switches, marked 1 2 and ON. They ship OFF: slide both to ON. Switch 1 lets the XIAO turn the screen's backlight off after the timeout; switch 2 lets it read a battery's charge if you add one later. Do it now: the XIAO covers them once it's on.

  4. 4

    Line the XIAO up under the display

    The XIAO goes on the display's back with the chip side facing away from the display, the long pins into the two rows of sockets, and the USB-C port facing out to the edge, or the port ends up covered. Leave the antenna on its cable to one side.

  5. 5

    Press it home and switch it on

    Push the XIAO evenly into the sockets until the plastic strips touch them. Then slide the small switch on the back of the display to ON; in the other position the screen stays dark.

  6. 6

    Plug it in

    USB-C to your computer for the setup below, and later to a phone charger where the switch lives.